|
Mediatechnics Systems
Inc.
TC 8000 Duplication Controller
Page 18
________________________________________________________________________________
Drive
Select Jumpers
Following are the R?Quest standard drive jumpering rules:
· The drive on the end of
the SCSI cable should have a termination jumper installed.
No other drives on the same SCSI cable should have a
termination jumper.
· All writers on the same SCSI cable must be
jumpered with a different drive select address. Address
7 (all 3 address jumpers on) must not be used on any
drive.
· No more than four 12X drives or three 16X drives
can be on a single SCSI cable.
NOTE:
While other cabling and jumpering
configurations that follow the above rules will work,
R-Quest only tests with systems jumpered per the following
figures. To insure compatibility with future firmware
and hardware configurations R-Quest highly recommends
that only the jumper configurations in the following
figures be used.
<Go
Back> <Next Page>
To Page 1,
2,
3, 4, 5,
6, 7,
8, 9,
10, 11,
12, 13,
14, 15,
16, 17,
18, 19,
20, 21,
22, 23,
24, 25,
26, 27,
28
|
