Toll Free : 1-800-474-8996

Fusion Manual HTML Format Page 7

System Startup 3
3.1 – Before Powering the unit on Before duplicating can begin, it is necessary to review a few details.
• Make sure the master power switch, located on the rear panel of the Fusion is set to “0” or off. (See page Error! Bookmark not defined. for a diagram of the rear of the unit).
• Plug one end of the supplied power cord into the receptacle at the rear of the unit.
• Next, verify that the voltage selector switch is set correctly. It is located above of the power receptacle. The Fusion supports both 115 VAC and 230 VAC at 50 ~ 60 Hz. Please confirm that the appropriate voltage (115 VAC for North America) has been selected.
Always use properly grounded receptacles, or severe damage to your system may result. The use of a surge protector or Uninterruptible Power Supply (UPS) is highly recommended.


< Previous Page / Next Page >

© Mediatechnics Systems Inc.

Equipment | Services | CD-R Media | Replication | Duplication | Silksceening | Supplies | Contact Us
DVD Production | DVD Authoring | CD Analyzer |Site Map | CD Duplicators Home